We design & manufacture Induction Heating Systems which are used for hardening, annealing, stress relieving, pre & post heating of job during welding as well as many other application as pre customer requirement.The working principle of inductive heating system is based on an alternating current flowing through a single or multiple turn coil also called as inductor.This inductor crates an alternating magnetic filed at high frequency in its proximity.So when any magnetic material or electrically conductive material is present in this highly alternatic magnetic filed heat is generated in that material. The amount of heat generated depends upon the power of the induction unit, the frequency,the gap, the material etc.

TECHNICAL SPECIFICATION:-

PARAMETER TECHNICAL SPECIFICATION
Model/Rating 10 KW to 200 KW & more powerful machines on customer request
Input Mains 3 Phase, 440 VAC ± 10%
Frequency 47 to 53 Hz
Inrush Current
115% of full load rated input power
Inductor Frequency
PWM 50 Hz to 200 Khz
Waveform
Pure Sine Wave
Power Factor
0.8 lag to Unity
Overload
110% for 20 min or 140% for 5 sec.
Overheating Protection
Cooling water recirculating system
Temp. Ambient
0 to 55°
Humidity
Up to 95% RH
Cabinet
Pedestal / Castor Wheel
Protections & Panel Indicators
Over Current / Over Temp. / Water Fail safe indicator /
Single Phase / Phase Shift
SALIENT FEATURES OF OUR SYSTEMS:-
1) Fast, Flame less, Economical & suited for automation.
2) Reduce Formation of Oxides.
3) Energy Transfer occurs without contact.
4) Designed for long life Performance.
5) Water cooling recirculating system for coils & inverter.
Press Esc to close